Because of the small lightening connector the 2:1 heat-shrink tubing slipped on easily. I applied this cool fix to my iPhone charger cable. As long as it's adhesive-lined it won't matter if it's either ratio because the glue will fuse the tubing to the cable regardless. I bought a mix of heat-shrink tubing and chose the size that slides over the lightening connector the easiest it could have been either the 1/4" or 3/8" diameter-I wasn't paying particular attention, but it fit the connector-the largest part-with enough room to slide the tubing over it. See the updated pics using the RED tubing. So I did a do-over with the original cable and added a piece of metal (I cut a piece of a paper clip) to give some sturdiness where the cable meets the connector. single walled adhesive-lined tubing but there's also a dual-walled type if you want to research this option). I realized the shrink tubing should have been the heat-activated ADHESIVE-LINED type that I mention at the end of the first section in Step 1 (I used 1/4". I found the regular shink tubing started to stretch and eventually started slipping on the power cord.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |